Ancon AMR Masonry Reinforcement
Ancon AMR is a steel reinforcement system that locates in the bed joint to strengthen masonry panels without thickening the wall.
The longitudinal steel wires are flattened to less than 3mm to ensure good mortar cover is maintained, even when lapped or used with wall ties. Cross wires are welded in the same plane.
Available in various standard configurations, the Ancon AMR suits a wide range of structural load conditions and wall widths up to 215mm.
60, 100, 150, 175mm
3.0, 3.5, 4.0, 4.5, 5.0mm (equivalent diameter after flattening)
Stainless steel, Galvanised steel
Flattened to less than 3mm
AMR Masonry Reinforcement is featured in CADS Masonry Wall Panel Designer.
Ancon has won a 2018 Queen’s Award for Enterprise in the Innovation category, for the successful introduction and on-going development of its advanced composite, low thermal conductivity, Teplo wall tie range.
Ancon is proud to announce the launch of its new company and brand logos as part of its on-going evolution.